
Gecko Dtec Pressure Switch 1.8PSI S-Class and M-Class
The Dtec-1 pressure switch is very easy to install and will replace all Gecko pressure switches for the following - Gecko S-Class, M-Class, U-Class...
View full detailsThe hot tub pressure switch is an integral part of any hot tubs equipment. Installed on the heater unit, the pressure switch will measure the water pressure travelling through the heater to make sure that it is not heating whilst suffering low pressure or no flow due to a pump failure or blockage.
The pressure switch will relay the information to the spa pack control board that then sends the information to the top side panel with an error code.
The following codes will warn you of either a pressure switch or flow switch failure:
The Dtec-1 pressure switch is very easy to install and will replace all Gecko pressure switches for the following - Gecko S-Class, M-Class, U-Class...
View full detailsThe Harwil flow switch 4090540 is the replacement for all Gecko controlled hot tubs. Specifications 1/2" NPT x 3" Length Replaces Pacific, Sundanc...
View full detailsThe Harwil flow switch 4090540 is the replacement for all Beachcomber hot tubs. Specifications 1/2" NPT x 3" Length Replaces Beachcomber Flow switch
The Tecmark pressure switch model 4010P 1/8" MPT male-part threads plastic is perfect for salt water & high moisture areas. 0.5 to 11 P.S.I. ad...
View full detailsThe Tecmark pressure switch model 4028P 1/8" MPT male-part threads plastic is perfect for salt water & high moisture areas. 0.5 to 11 P.S.I. ad...
View full details